Why the mask earloop different length ?

July 28, 2021
微信图片 20220121101522 1

Ear wire length is not the same solution

  1. Check if the cutting position is completely cut.
  2. the left side of the long on the right side of the scissors tilt, the right side of the long on the reverse.
  3. Single is short or long near the pull cord cylinder side, directly adjust the manual third page of the front and rear pull cord reset offset position.
  4. You can also adjust the manual third page of the front and back of the pulling ears to take the position of the line position to control.
  5. If the unilateral ear line is too long, you can adjust the length of the rubber block below the release ear motor.
  6. The overall adjustment of long or short can be set by setting the second page of the pressure ear cylinder delay down time to control the length of the ear line
  7. Can also be controlled by the following drive dial code.

Contact Us

No. 24, Cai Bai Coastal Road 3,Daojiao Town, Dongguan, China
+86 15966681218
2022, Copyright HGMAC All Rights Reserved.
crossmenu